Cut and trim clips on the timeline
Split a clip with the Razor, remove a piece without leaving a gap, and trim an edge to tighten the cut.
Playlist Editing basics
0 of 4 done
Most editing is cutting: splitting a clip where the good part ends, removing what you do not need, and nudging edges until the cut lands on the beat. This lesson cuts the sprinter shot in two, throws the second half away and closes the gap, then trims the next clip's end.
Step 1 of 4
Pick the Razor tool
The tools sit in a column on the left of the timeline. Click the Razor, or press C. Its icon turns blue while it is armed, and the lanes show a crosshair pointer.
- CRazor tool













Step 2 of 4
Click the clip where you want to cut
Move the pointer over sprinter_A012.mov. A thin white line follows it, snapped to the frame: that is where the cut will go. Click at 00:09:00, just after the sprinter leaves the frame. The clip becomes two clips.
Shift-click cuts every track at that frame. To cut at the playhead without the tool, select the clip and press Ctrl+K.
- CtrlKAdd Edit: split at the playhead













Step 3 of 4
Remove the second half and close the gap
Press V for the Selection tool and click the right-hand piece to select it. Press Shift+Delete: Ripple Delete removes it and slides every later clip left, so no gap is left behind.
Plain Delete removes the clip and leaves the gap where it was.
- ShiftDeleteRipple Delete
- VSelection tool














Step 4 of 4
Trim an edge to tighten a cut
With the Selection tool, hover the end of spikes_C031.mov. The last 7 pixels of the clip light up: that is the trim handle. Drag it left to make the clip end sooner.
With Ripple Edit (B) armed instead, the same drag also pulls every later clip along. Or park the playhead and press W to ripple-trim the clip's end straight to it.
- BRipple Edit tool
- QRipple trim the previous edit to the playhead
- WRipple trim the next edit to the playhead











Cut, cleaned and tightened
Those are the moves you will make hundreds of times: Razor or Ctrl+K to cut, Shift+Delete to remove without leaving a gap, and edge drags or Q and W to trim. Slip (Y) and Slide (U) change what a clip shows without changing the cut points.