Add a transition between two clips
Put a Cross Dissolve on a cut from the Library's Transitions tab, or with Ctrl+D, and adjust its length.
Playlist Editing basics
0 of 4 done
A transition replaces a hard cut with a dissolve, a wipe or a push. In Premation the transitions are in the Library panel, shown as pictures of the effect. One click puts one on the cut of the clip you have selected.
Step 1 of 4
Select the clip before the cut
Click sprinter_A012.mov. Its end meets spikes_C031.mov at 00:16:00, and that cut is where the transition will go: a click on a transition prefers the cut at the end of the selected clip.













Step 2 of 4
Open Window, then Library
Choose Window, then Library, and click its Transitions tab. Every transition shows as a small picture of the two shots blending, sorted into chips such as Dissolve, Slide, Wipe and Zoom.


Step 3 of 4
Click Cross Dissolve
Click Cross Dissolve (default). It is added to the cut straight away and a message confirms it.
Faster still: with the clip selected, press Ctrl+D to apply the default transition without opening the Library.
- CtrlDApply Default Transition

























Step 4 of 4
Check it on the timeline
The transition sits on the cut as a block with a blue line at the cut point and its length, 1.0s. Drag either end of the block to make it longer or shorter.
Click the block to select it: Effect Controls then shows its Duration and Alignment (Center at Cut, Start at Cut, End at Cut). Press Delete to remove it.

























The cut dissolves
A transition needs spare frames on both sides of the cut. If Premation says the clips need spare media beyond the cut, trim a few frames off each side and try again.