Animate a clip with keyframes in Effect Controls
Give a static shot a slow push-in with two Scale keyframes, set from the stopwatch in Effect Controls.
Playlist Animate on the timeline
0 of 2 done
A slow push-in turns a static shot into a moving one. You set two keyframes on the clip's Scale: one where the move starts, one where it ends, and Premation fills in every frame between.
The same steps animate Position, Rotation and Opacity.
Step 1 of 4
Select the clip and go to its first frame
Click the clip on the timeline, then press Up until the playhead sits on the clip's first frame. Up and Down jump between edit points, so you land exactly on the cut.
- UpGo to the previous edit point
- DownGo to the next edit point













Step 2 of 4
Open Window, then Effect Controls
Choose Window, then Effect Controls. Every clip has the same fixed effects at the top: Motion, Opacity and Time Remapping. Anything you add from the Effects panel is listed below them.


Step 3 of 4
Turn on the stopwatch next to Scale
In the Motion group, click the stopwatch to the left of Scale. It turns blue, and a keyframe is set at the playhead with the current value, 100.0. The ◂ ◆ ▸ buttons that appear on the right step between keyframes and add or remove one at the playhead.


Step 4 of 4
Move the playhead and change the value
Move the playhead toward the end of the clip, to about 00:00:14:00. Drag the Scale number to the right, or click it and type 115. Because the property is animated, the change becomes a second keyframe on its own.
Press the spacebar to play. The shot now pushes in slowly over thirteen seconds.
- SpacePlay and stop
Click the stopwatch again only if you want to throw the animation away: it removes every keyframe on that property.


The shot moves
To see and drag the keyframes in time, press Show Timeline View in the Effect Controls header: it opens a keyframe lane for the clip beside the controls. Animate Opacity the same way for a fade.